
Filling the RinseAid Dispenser
IMPORTANT
, Rinse aid is important to the drying process of the dish-ware_ It
also reduces spotting Dacor recommends that you keep the rinse
aid dispenser full at al time&
' The RINSE AID light on the control panel turns on when it is time
for you to refill the rinse aid dispenserl There is also a rinse aid
indicator on the dispenser that turns 'clear" when the dispenser is
emptyl
The rinse aid dispenser must be properly adjusted. Too
little rinse aid will allow spotting and drying problems.
Too much rinse aid will cause foaming and streaking.
A rinse aid with citric acid may be used to remove the
white or gray film caused by very hard water.
To refill the rinse aid dispenser:
1. Turn the rinse aid cap counterclockwise to the
open position and lift it out.
2. Carefully pour the rinse aid into the filler hole
until the rinse aid level is even with the bottom
of the hole. Do not overfill.
3. Wipe up any spillage,
4. Replace the rinse aid cap and turn it clockwise to
the closed position.
Adjusting the Rinse Aid Dispenser
The rinse aid setting is located under the rinse aid cap. It
is set at the factory to 4.
To change the setting:
1. Remove the rinse aid cap.
2. If you have spotty or improperly dried dishes, move
the rinse aid setting to the next higher number. If
you have streaks on your dishes, move the rinse
aid setting to the next lower number. The harder
the water, the more rinse aid required for accept-
able results.
3. Replace the cap.
4. Check the dishes after the next wash load. Con-
tinue adjusting the rinse aid dispenser up or down
according to the guidelines above until you have
spot free, streak free, dry dishes.
If you have very soft water and still experience streaking
when the dispenser is set to 1, you can dilute the rinse aid
with water before pouring it into the dispenser to get ac-
ceptable results.
I
// i \\
I
I
\ /
\ /
/ \
/ \
I
Rinse-Aid Indicator
on Dispenser
Open
1 LlOSeO
I
Use and Care Manual
Comentários a estes Manuais